TOTAL GYM
®
FUSION OWNER’S MANUAL |
SET UP
5
Lift Here
Front Crossbar
Back Crossbar
Hold Here While Lowering
To The Ground
Set Up
Your product comes with:
•
Safety Hitch C Pin
to be inserted into side hole located directly below Height Adjustment Assembly on Vertical Column.
•
Height Adjustment Quick Release Pin
located on side of Vertical Column for raising and lowering rails.
•
Spring Loaded Pin
locked into the base of the Left Rail by the Height Adjustment Tube. Left side is determined by standing behind the
unit facing the Vertical Column.
IMPORTANT:
To prevent injury, be sure the Spring Loaded Pin is locked securely into place in the Left Rail before using unit. This will
prevent the Height Adjustment Column from falling forward.
•
Safety Pin
located on Lanyard/attached to Height Adjustment Tube.
•
4 Short Hitch Pins
for the Ab Crunch and Wing Attachments and
1 Large Hitch Pin
for the Leg Pulley Bracket (located in the
Miscellaneous Section of the Accessory Kit.)
IMPORTANT:
Before using Ab Crunch, Wing Attachments and Leg Pulley Accessory, be sure the Hitch Pins are securely inserted (see
pages 7-10 of this manual for directions).
1.
Pull the product out of the shipping box. Remove all packaging
materials, including tape and cardboard inserts, from your unit.
NOTE:
Some parts are packed inside the Rails.
2.
Lay product on the floor with glideboard side up. Make sure
you have plenty of space on both ends of the product. Slide the
glideboard as far as it will go towards the Front Crossbar before
you begin lifting unit.
3.
Lift the exerciser up by holding it at the top of the rails.
Using your foot, slowly spread the unit open at the bottom
approximately 12 inches so that it rests firmly on the Front and
Back Crossbars not allowing it to go too far.
4.
Make sure the handles are out to the sides before you begin to
unfold your unit. Keep hands and fingers away from pulley. Hold
onto the top center of glideboard and begin rolling rear rollers.
Spread the unit out until it is flat on the floor. Be careful to do
this
slowly
.
Be sure to support the frame in the center to avoid having
the product drop suddenly onto the floor or pinch fingers.
