TOTAL GYM
®
FUSION OWNER’S MANUAL |
ACCESSORIES: HOW TO’S
11
ASSEMBLY
1. Carefully place the Insert Tube Assembly on a flat, level surface with the front
screw holes facing up. Place one Foot Platform Assembly onto the Insert Tube
Assembly making sure the holes on the Spring Plate are lined up with the front
screw holes and the bottom screw holes on the Insert Tube Assembly. Thread
four sets of M6 x 15 bolts through the holes on the Spring Plate into the 2 front
screw holes and 2 bottom screw holes on the Insert Tube Assembly and first
tighten by hand. Once all bolts are in, then tighten with supplied wrench.
2. Repeat Step 1 for the second Foot Platform Assembly.
How to Attach the STEP Attachment
INSTALLATION
1. Attach the assembled Total Gym STEP to
your Total Gym unit by inserting it into the
Front Crossbar as pictured below. Make
sure it is fully inserted.
NOTE: Remove the Total Gym STEP when
you are not exercising with it.
SUGGESTED EXERCISES
SQUAT, PLYOMETRIC, REBOUND
Both feet on attachment at the same time.
Use both legs simultaneously for a variety of
squat and plyometric squat (jumping) exercises.
Energy-absorbing springs reduce joint stress
allowing for greater muscle exercise.
WALK, JOG
Alternate feet.
Alternate your step pattern for independent
walking or jogging exercises to enhance
balance and stepping strength with low-impact
on joints.
CIRCUIT TRAIN
Use Total Gym STEP between strength
exercises to enhance the aerobic activity of the
workout.
Insert Tube
Assembly
Foot Platform Assembly
M6 X 15
M6 X 15
Spring Plate
Bottom
screw holes
Front
screw holes
Wrench