8
INCLINE ROWER CE OWNER’S GUIDE |
COMPUTER / ROLLER REMOVAL
COMPUTER / ROLLERS
Computer Instructions
TO TURN ON:
Press the button or start
rowing.
TO TURN OFF:
Press the button or after
30 seconds of immobility the computer will
shut itself off automatically. During those 30
seconds, the computer remains in pause
mode. If you continue to row the computer
will resume from where you left off.
TO RESET:
Press the button twice.
CHANGING BATTERIES
The computer runs on two AA batteries.
Remove the 4 screws from the front
computer display with a Phillips screwdriver.
When changing the batteries ensure all
wires remain intact. Carefully tuck the
wires into the back of the housing and
replace the front display when complete.
Battery Life = approximately 1 year for
home use, 6 months for commercial use.
Time = Total Time
Split = Minutes per 500 meters
Stroke = Strokes per minute
Distance = Total distance
Calories = Total calories burned
Seat or Foot Platform:
Roller Removal & Assembly
STEP 1.
Using a 4 mm Hex wrench,
remove the 6 M6 screws (3 on each side)
from the rail endcaps.
STEP 2.
Roll the seat up and off the end
of the rails. Then roll the foot platform off
the end of the rails.
STEP 3.
To remove the rollers use a
13 mm socket wrench and a 13 mm
open-end wrench.
STEP 4.
Insert socket wrench over the bolt
on the outside of the roller as you engage
the open-end wrench on the nut on the
inside of the frame; turn to unscrew.
NOTE:
Hex wrench, socket wrench and
open-end wrench, not included.
Bolt
Nut
STEP 5.
Replace the rollers as needed
and reinstall the bolt and nut. Tighten just
enough so that the wheel can roll but does
not slide lengthwise on the axle. DO NOT
OVER TIGHTEN.
STEP 6.
Return the foot platform back to
the unit by rolling it down the rails. Repeat
with the seat.
STEP 7.
Replace the endcaps on the rails
and ensure all 6 screws are tight.
