6
ASSEMBL
Y & INST
ALL
INCLINE ROWER CE OWNER’S GUIDE |
ASSEMBLY & INSTALLATION
Assembly & Installation
STEP 1.
Remove all the top styrofoam.
Find and keep the hardware box. Take the
Row Trainer out of the box and set it on
the floor.
STEP 2.
Cut the tie wraps and remove
the rest of the packing material except for
ones clearly marked “DO NOT REMOVE
until rotating the mast”.
STEP 3.
Rotate the mast to vertical.
Remove any visible cardboard under the
mast.
STEP 4.
There are 3 cables that hang
below the mast, be sure that they are not
being pinched when you rotate the mast
further.
Now move the mast as far as it can go.
STEP 5.
Install x8 M8x20 screws and
washers found in your hardware box to the
front and back of the foot platform, (you
can move or wiggle the mast to align the
holes) and tighten after all 8 screws are
installed.
Seat
side
Floor side
STEP 6.
Slide the foot platform and seat to
the base. Go to the rear of the Row Trainer
and lift rails so the legs unfold and are
locked into place with Incline Knob (Pop
Pin). Set the Row Trainer down.
Incline
Knob
(Pop Pin)
STEP 7.
Set the handle on to the handle
cradle. Your new Incline Rower CE is now
ready to use.
OPTION:
Please see page 7
on how to add the resistance band if you
want additional resistance.
CHANGING RESISTANCE
There are two levels of resistance.
At the back of the unit, find yellow
incline knob. Lift or lower knob until
the legs are in place, and engage
knob.
Incline Knob
(Pop Pin)
SCAN TO WATCH
ASSEMBLY VIDEO
