9
ELEVATE
®
PRESS
TM
OWNER’S GUIDE
ELEVATE
®
PRESS
TM
OWNER’S GUIDE
ROLLERS / MAINTENANCE
GLIDEBOARD:
ROLLER REMOVAL AND ASSEMBLY
STEP 1.
Remove the six M6 screws
from the Rail End Caps on the top end of
the rails with a 4 mm Hex Wrench (not
included) and remove the end caps.
STEP 2.
Roll the glideboard up and out
the top of the rails and set it upside down
on a clean smooth surface.
STEP 3.
To remove the rollers use a 13
mm socket wrench and a 13 mm open-
end wrench.
Insert socket wrench over the bolt on the
outside of the roller as you engage the
open-end wrench on the nut on the inside
of the frame; turn to unscrew.
NOTE:
Socket wrench and open-end
wrench not included.
Nut
Bolt
STEP 4.
Replace the rollers as needed
and reinstall the bolt and nut.
Tighten just enough so that the wheel can
roll but does not slide lengthwise on the
axle. DO NOT OVER TIGHTEN.
STEP 5.
Reinstall the glideboard by
carefully and slowly rolling it back into the
rails.
STEP 6.
Replace the Rail End Caps on the
rails and insure all 6 screws are tight.
MAINTENANCE
AND CARE
Your ELEVATE Press unit will offer you
years of easy operation if you follow
these simple tips for maintenance
and care. With periodic cleaning,
moving parts and rolling surfaces will
maintain their smooth function. Clean
rail surfaces on a regular basis with
a noncorrosive cleaner like soap and
water or waterless cleaner or just wipe
clean with a dry towel. Some black
powder residue is normal on the inside
of the rails. All other parts can be
cleaned the same way or antibacterial
wipes may be used.
CAUTION!
DO NOT USE ANY
LUBRICANTS OR SILICONE-BASED
PRODUCTS on the rails or wheels.
This will cause the wheels to slide
rather than roll and will damage the
wheels. Use a non oil–based window
cleaner on the glideboard material.
DO NOT USE ARMOR ALL
®
OR LIKE
SUBSTANCES. These will make the
glideboard slippery. Wipe down your
ELEVATE Press with a clean cloth.
MAINTENANCE SCHEDULE
DAILY
1. Wipe down all padded surfaces with
antibacterial cleanser after each use.
2. Move the glideboard up and down
rails to ensure smooth rolling. If the
glideboard does not roll smoothly,
clean rails and wheels thoroughly with
a soft lint-free cloth.
WEEKLY
1. Wipe down rails with a non-corrosive,
no alkaline, no alcohol cleanser.
2. Clean all surface areas for aesthetics.
3. Check all screws. Fasten to ensure
they are installed correctly and
tightened.
4. Check all pads for wear and replace as
needed.
MONTHLY
1. Visually inspect the rollers. Clean any
debris accumulated on the roller.
2. Inspect rubber stoppers.
3. Replace all parts that show signs
of wear. Contact Customer Service
in USA at 858-586-6080 or email
[email protected]. For
international customers, contact the
approved distributor in your country.
