7
ELEVATE
®
PRESS
TM
OWNER’S GUIDE
ELEVATE
®
PRESS
TM
OWNER’S GUIDE
ASSEMBLY
ASSEMBLY INSTRUCTIONS
TWO PERSON ASSEMBLY REQUIRED.
STEP 1.
Carefully unpack all the parts and
the Information & Hardware box at the
installation site if possible.
A
Rail Base & Handle Bars
B
C
STEP 2.
Open the Information & Hardware
box. Inside there will be:
Long M8 Button Head Screws & Washers (10)
5 mm
Hex Wrench
M6 Button Head
Screws & Washers (4)
Short M8 Button Head Screws & Washers (8)
M8 Hex Head Screws
& Washers (2)
4 mm
Hex Wrench
13 mm
Open End Wrench
STEP 3.
Turn
A
upside down. Set Rail
Base & Handles in place at bottom of rails
as shown (wheels should face away from
the unit).
STEP 4.
Using the 5 mm Hex Wrench
install two M8 Button Head Screws
with washers as shown. Do not tighten
completely.
STEP 5.
Using the 13 mm Wrench install
the two M8 Hex Head Screws with
washers near the end cap at the base of
the unit. Do not tighten completely.
STEP 6.
Using the 4 mm Hex Wrench
install four M6 Button Head Screws with
washers under the Rail Base & Handles
into the rails as shown. Do not tighten
completely.
STEP 7.
Once all six screws have been
installed, go back and tighten each
completely.
