TOSINGRAF DPG330M, Owner'S Manual

Page: 36 / 41

32 RE V. 2.0- 06/20
For hot lamination, the upper and lower coils must have the same width and must be aligned with each other. If the films are not
aligned, loosen the bolt on the roller adapter and align them
The glossy side of the film must be in contact with the roller, while the opaque side covered with adhesive must be in contact
with the material to be laminated.
Make sure the film is loaded from the correct side.
The protective screen must be positioned above the upper rollers and the feeding table must be in position when the machine is
turned ON before pressing the green start button..
a) loosen the clutch on the spool holder shaft through the
appropriate knob;
b) remove the spool holder from the machine supports;
c) remove the screw in order to extract the reel holder adapters
insert the roller adapter, the adapter must keep the roll of the
film blocked to prevent its rotation during the laminator
operation;
d) tighten the locking screw on the adapter to block the
movement of the roll
e) place the roll on the supports
f) perform the same operations to install the lower roll
g) after installing and loading the rolls on their respective
supports, loosen the upper and lower roller tension knobs by
about half a turn so as to allow the rollers to slide easily
h) widen the heating rollers by turning the knob (10)
i) move the lower stabilization bar forward to allow the passage
of the lower film
j) insert the upper and lower film between the heating rollers
following the direction indicated in the following diagram
k) move the lower stabilization bar to the working position
l) approach the heating rollers by turning the knob (10)
Ch a P t ER 6: usE