TOSINGRAF DPG330M, Owner'S Manual

Page: 33 / 41

RE V. 2.0- 06/20 Pl a st i 330 29
Next view will provide overlook of selected temperatures on both rollers in the range 50-170° C. It’s immediately possible to set upper
roller’s temperature by turning the knob and confirming it by pressing the knob it self the selection will switch to lower roller. The setting
will always need knob pressure in order to be confirmed.
°C
°C
120
120
Image 6.3
It’s possible to deactivate the heating on one or both rollers. In temperature setting section’ (Image 6.3) just turn the knob counter-clockwi-
se the control knob until OFF value will be displayed (right after 50° C).
When the lower roller is set to OFF the temperature of upper roller only will be displayed in main screen.
If both rollers are set to OFF, in main screen “COLD” indication will appear instead of actual temperatures.
°C
OFF
120
Image 6.4
After setting the temperature and confirming the selection by pressing the Control knob, the temperature showed in main screen will blink
slowly same as the red light (6) showing the machine is warming up.
When the target temperature is reached the value showed on the display will stop blinking same as the red light (6).
During the warming up it is anyway possible to activate rollers turning by pressing the green button (3), note that the quality of the lamina-
tion is not guaranteed as the operating temperature may be insufficient with respect to the technical specifications of the material used.
When the maximum temperature of 150 ° is reached by the mechanical structure of the machine, a safety thermal fuse auto-
matically trips..
s
Peed adjustment
The speed is adjusted by turning the control knob (2) so that the display dial relating to the operating speed is highlighted (Image 6.5) and
confirming by pressing the knob (2)
°C
°C
120
120
3
∑
Image 6.5
ENG
Ch a P t ER 6: usE