![background image](http://html.mh-extra.com/html/toshiba/trst-a10-series/trst-a10-series_user-manual_429122059.webp)
TRST-A10/TRST-A15 POS Printer OPOS Control Application User’s Manual
TOSHIBA TEC CORPORATION EAA-02450
59
3. Control Panel
This chapter describes the Control Panel which is installed by the installer.
For the setup details, please refer to the section, “1.1.7 OPOS Registry”.
3.1 Overview
You can easily make the common registry settings for the TRSTA1x POS Printer OPOS Control by installing
the OPOS in an execution environment.
Available settings are as follows:
Value
Description
Port
A port, used to connect with the printer device, can be
selected from the list box.
BaudRate
A communication speed with the printer can be selected
from the list box. The value should be the same as the
baud rate setting of the printer device.
Country
A country code can be selected from the list box.
Paper Width
Printer paper width can be selected either from 80 mm or
58 mm.
The value should be the same as the paper width setting
of the printer device.
Use Override Mode
An operational mode of the RotatePrint method can be
set to Override mode by checking this checkbox.
Print Mode
(*1)
A default print mode when using the OPOS can be
selected from the front side mode (printing only on the
front side) and the three back side print modes (printing
only on the back side).
Swap Front Side and Back Side
(*1)
A print side (front or back side) can be switched by
checking this checkbox.
Upside Down
(*1)
Upside Down Print on the front/back side is enabled by
checking this checkbox
Minimum Receipt
(*1)
A minimum receipt length for printing in Transaction1
mode can be specified in dots.
(*1)
These values can be set using the printer device setting, but the OPOS Control ignores the
printer device settings and enables the settings made from the Control Panel.
Table 26 TRSTA1x POS Printer Control – Available Settings from Control Panel