T200, T200CS
3-41
The following prompts display at the bottom of the screen in succession:
Drive number select (1:#1,2:#2) ?
(a)
Select a drive number and tap or press
Enter
. The following message
appears:
Interleave number (1/1 ~ 8) ?
(b)
Select an interleave number (1 ~ 8) and tap or press
Enter
. Tab or press
Enter
only to select
1
.
(c)
Bad Track Register
Next, the Bad Track Register prompt appears. Enter the bad track cylinder
and head numbers and tap or press
Enter
. If there are no bad tracks, tap or
press
Enter
only to execute All Track Format as described in Item (d)
below.
[ WARNING : Current DISK data will be
completely destroyed ]
Press Bad cylinder number (dddd)] key ?
Press Bad head number (dd)] key ?
Enter the cylinder and head number in the format above in decimal notation.
Repeat for each bad track to format.
After entering the bad tracks, tap or press
Enter
to execute the format.
(d)
All Track Format
All tracks are formatted as good tracks except those registered as bad tracks
in Item (c) above, or identified as bad tracks in the Track Verification func-
tion described in Item (e) below.
(e)
Track Verification
A check is made of all tracks, and if an ECC, ECC-correctable, or record-
not-found track error is detected, the track is formatted as a bad track .
Summary of Contents for T200
