Toshiba Satellite A40 Series, Maintenance Manual

Page: 355 / 419

4.26 Fluorescent lamp 4 Replacement Procedure
Setting the bezel
1. Start installing the bezel in the upward direction until it stops at the top left corner.
CAUTION: The GND-CU and lamp reflector on the left-hand side must not go beyond
the edges of the bezel.
Be careful not to damage the cables and TAB.
The bezel latches must be engaged (there are five latches on the top edge,
and two latches on the bottom edge).
ラ ッチ ２箇所有 り ．
をはめる ．
と
2
2
2
2
2
1
Two latches
ベゼルの外に出ない こ
リ フレ ク タ折 り曲げ有 り ．
The fold of reflector must not go
beyond the bezel’s edge.
ベゼルの外に出ない こ と ．
ＧＮＤ－ＣＵ折 り曲げ有 り ．
The fold of GND-CU
must not go beyond the
ケーブルをキズつけないよ うに注意
ベゼルを ラ ンプ側か らはめる ．
First, fit the bezel’s edge close to the
lamp. Use care not to damage the
bl
ラ ッチ ５か所
次にた Ｔ ＡＢ側をはめる ．
Next, fit the bezel’s edge
close to the TAB.
Close the five latches.
Figure 4-72 Replacing 14 Inch TMD fluorescent lamp (10)
Satellite A40 Maintenance Manual (960-458) 4-89