– 65 –
FILE NO. SVM-02001
4 mm
No.
Part name
Procedures
Remarks
4
5
6
Heat exchanger
Cross flow fan
Base bearing
1) Remove the front panel, electrical part and the
horizontal louver following procedure 3.
2) Remove the pipe holder at the rear side of main
unit.
3) Remove the 2 screws on the heat exchanger at
the base bearing.
4) Remove the 2 screws on the heat exchanger at
the 2 fixed plates (upper and lower) from the
back body, and then pull out the upper side of
the heat exchanger slowly.
1) Remove the front panel, electrical part, horizon-
tal louver and the heat exchanger following
procedure 4.
2) Remove the 2 screws on the band motor (L) and
remove the 2 screws on the band motor (R) and
then remove the cross flow fan.
3) Loosen the set screw of the cross flow fan then
separate the fan and the fan motor.
Notice
To assemble cross flow fan and fan motor to the
unit, please turn the fan motor unit the center of its
terminal meets the lowest point of band motor (R)
(point A).
Fix the cross flow fan with the set screw at the
position where the gap between the back body and
the right surface of the cross flow fan is 4 mm.
1) Remove the front panel, electrical part, horizon-
tal louver, heat exchanger and the cross flow fan
following procedure 5.
2) Remove the 2 screws fixing the base bearing.
3) Remove the bearing from the base bearing. If
the housing protrudes from the base bearing,
put the housing in position and attach the
bearing to the base bearing.
3
2-Screws
2
Pipe holder
2
2-Screws
(R)
2
2-Screws (L)
Middle of the fan motor terminal
2
2-Screws
4
2-Screws
6
Set screw
