GR
NL
PT
ES
IT
DE
FR
RU
SI
SK
LV
CS
TR
EN
19-EN
R (L)
S (N)
–19–
Toshiba 1112750201 (EN)
Installation Manual
Wiring connection for fl ow selector unit
How to connect the wiring of fl ow selector unit
Connect the power supply wire and the communication wire supplied with the fl ow selector unit to the indoor unit.
1. Removing the front panel.
2. Remove the terminal cover and cord clamp.
3. Take a power supply wire and control wire
(according to the local rule) into the pipe hole on the hole.
4. Take the power supply wire out of the cable slot on the rear panel so that it produces about 430 mm from the front.
5. Insert the power supply wire fully into the terminal block and secure it tightly with screws.
Tighten torque: 1.2 N/m (0.12 kgf/m)
6. Insert the power supply wire faston terminal of the fl ow selector unit into the power supply terminal.
Secure the earth line with the earth screw.
7. Connect the control wire connector of fl ow selector unit to the control wire.
8. Clamp the power supply wire with the cord clamp.
9. Attach the terminal cover with a screw
10. Take the control wire out of the cable slot on the rear panel so that it produces about 600 mm from the front.
11. Remove the terminal cover (UP)
12. Remove the LED BASE
13. Insert the control wire fully into the control/Wired remote controller terminal block
,
,
,
and secure it
tightly with screws.
14. Clamp the control wire with the cord clamp.
15. Attach the LED base, terminal cover (UP) and front panel
Cord clamp for
fl ow selector unit
Cord clamp
Connector
Power supply wire
of fl ow selector unit
Control wire from
the fl ow selector
Power supply terminal block
Earth screw for
fl ow selector unit
Control wire
Summary of Contents for MML-AP0074NH-E
Page 2: ......