18-EN
–18–
Toshiba 1112750201 (EN)
Installation Manual
U1
A
B
U2
230
230
10
10
Shield wire
<Stripping length of the control wire>
Control wire
Remote control wire
Screw
Display base
Slot for fi x LED base
Hook for fi x LED base
Slide right side to
remove LED base
2) How to connect the control wiring
1. Take the control wire out of the cable slot on the rear panel so that it produces about 600 mm form the front.
2. Remove the terminal cover (UP)
3. Remove the LED BASE
4. Insert the control wire fully into the control/Wired remote controller terminal block
,
,
,
and secure it
tightly with screws.
5. Clamp the control wire with the cable clamp.
6. Pass the banding band through the hole of the mount base.
7. Band the control wire and the remote controller wire in the banding band.
8. Attach the LED base, terminal cover and front panel.
<Connecting control wire and remote controller>
<How to remove LED base>
Control wire
Remote controller wire
Terminal block for control/wired
remote controller wiring
Earth screw for
shield wire
Shield wire for
earth wire
Cable
clamp
LED base
600 mm
Summary of Contents for MML-AP0074NH-E
Page 2: ......