– 50 –
Changing of settings for Celsius display
• Push
button if the unit stops.
Procedure
1
Push simultaneously + + buttons for 4 seconds or more.
After a while, the display part flashes as shown right. Check the displayed CODE No. is [
10
].
• When the CODE No. is other than [
10
], push button to erase the display and repeat procedure from the
first step. (After pushing button, operation of the remote control is not accepted for approx. 1 minute.)
(For a group control, No. of the firstly displayed indoor unit becomes the header unit.)
Procedure
2
Every time the button is pushed,
UNIT LOUVER
(button at left side), the indoor unit No.
in the group control is displayed in order. Select the indoor unit of which setup
is changed.
In this time, the position of the indoor unit of which setup is changed can be
confirmed because fan of the selected indoor unit will operate.
Procedure
3
1. Using temp. setup
buttons, specify CODE No. [
33
].
(CODE No. [
33
]: Fahrenheit display)
2. Using timer
buttons, change the line address from [
0001
] to [
0000
]
3. Push button. In this time, the setup finishes when the display changes
from flashing to lighting.
Procedure
4
After verifying the content change, push button. (Setup is determined.)
When pushing button, the display disappears and the status becomes the usual stop status.
(When pushing button the operation from the remote control is not accepted for approx. 1 minute.)
• If the operation from the remote control is not accepted after 1 minute of pushing the button, it is considered
that the address setup is incorrect. In this case, the automatic address must be set up again.
When changing the settings from Celsius to Fahrenheit follow the reverse order of the above procedure.
4
6
1
5
3
2
CODE No.
UNIT No.
R.C.
No.
SET DATA
SETTING
CODE No.
UNIT No.
R.C.
No.
SET DATA
SETTING
SETTING
