– 19 –
Owner’s Manual
EN-37
EN-38
Floor standing cabinet type
When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
When heating
Move the louver manually and point it downward to send
heated air to the floor.
Changing the air discharge
Follow the procedure below to change the air discharge:
1
Remove the two fixing screws of the air
discharge. (The fixing screws are to be reused)
2
Insert your hand into the air discharge and pull it
up slightly, then remove the air discharge from
the claw hook at the rear side.
3
Lift up the air discharge and remove it.
4
Reverse the air discharge and reattach it to the
main unit.
Make sure that the four claw hooks (2 at the rear
and 2 at the lower sides) are hooked into the
mounting positions.
5
Be sure to tighten the air discharge with the
removed fixing screws so that it does not come
off.
9
Tips for Saving Energy and Comfortable
Performance
To save energy and perform comfortable cooling and heating
Clean the air filter often
• A clogged air filter lowers the cooling / heating
performance.
Do not cool / heat too much
WARNING
Do not expose your body to
cool air directly for a long time
and do not cool yourself
excessively.
Doing so may result in
deteriorated physical condition
and ill health.
• Cooling / Heating too much is bad for your health.
In particular, take care with handicapped / old people
and children.
Close windows and doors
• Do not let cooled / heated air escape from the room.
Cool / Heat the room evenly
• Adjust the air direction with the louver.
Exposing yourself to blowing air directly for a long time
is bad for your health.
Check
periodically!
Do not cool
down too
much!
Close.
2FAN_OM_DB04307201-04_EN.book Page 19 Tuesday, December 17, 2019 6:33 PM