Owner’s Manual
– 16 –
EN
Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
Setting the louver lock
1
Push and hold the
button (right side of
the button) for at least 4 seconds while running
is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the
button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to display the
number of the louver to fix its direction.
The selected louver swings.
4
Push the TIME
buttons to select the
direction of the louver you do not want to swing.
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the
button to confirm the setting.
When the setting is confirmed, the
mark lights up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
(3)
(2)
(1)
(1)
(4)
(2)
(3)
(2)
(3)
(4)
(1)
(4)
(3)
(2)
(1)
(4)
UNIT LOUVER
UNIT LOUVER
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
(1)
0001
(2)
0002
(3)
0003
(5)
0005
(4)
0004
6
Push the
button to finish the setting.
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver 01
shown in the following figure is selected.
NOTE
Even in louver lock mode, the louver temporarily moves
in the following cases:
• When the air conditioner is stopped
• When heating starts
• When defrosting
• When thermo. off.
Releasing the louver lock
Set “0000” in Step 4 of “Setting the louver lock”.
The
mark disappears.
* Steps 1 - 3 and 5, 6 of “Setting
the louver lock” also apply to
releasing the lock.
Adjusting the horizontal direction
1
Push and hold the
and “TEMP.
”
buttons for at least 4 seconds while running is
stopped.
blinks.
“01” appears in CODE No.
2
Push the
button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to change
the CODE No. to “45”.
4
Push the “TIME
”buttons to select a
direction.
5
Push the
button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push the
button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
Louver No.
0001 - 0005
(Louver position
code)
Electrical control box
Refrigerant
pipe
Drain pipe
0000
SET DATA
Direction SET
DATA
Direction setting
“0000”
Smudging reduction position
(reduces ceiling smudging)
(factory default)
“0002”
Cold draft position
(Less directly expose your body to
cool air)
UNIT LOUVER
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
No
display
EN-31
EN-32
2FAN_OM_DB04307201-04_EN.book Page 16 Tuesday, December 17, 2019 6:33 PM
