– 11 –
Owner’s Manual
EN-21
EN-22
3
Push the
button to confirm the direction of
the selected louver.
Each time you push the button, the indication
changes as follows:
* When cooling or drying, (4) and (5) are not displayed.
Setting the swing pattern
1
Push and hold the
button for at least 4
seconds while the operation is stopped.
blinks.
2
Push the
button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver swings.
3
Push the TIME
buttons to select a swing
type.
REQUIREMENT
Do not set “0000”.
(The louver may be damaged.)
4
Push the
button.
5
Push the
button to finish the setting.
Standard swing
All four louvers swing simultaneously at the same
angle.
Dual swing (Recommended for heating)
• Adjoining louvers alternately point horizontally and
downward to heat the room evenly.
• Air blown downward reaches the floor, and air blown
horizontally is spread to circulate heat.
Swing code
Movement pattern
0001
Standard swing
(factory default)
0002
Dual swing
0003
Cyclic swing
SWING/FIX
(1)
(2)
(3)
(4)
(7)
(6)
(5)
SWING/FIX
UNIT LOUVER
Unit No.
1-1
No
display
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
Swing code
Swing
Horizontal
Horizontal
Downward
Downward
Horizontal
Horizontal
Downward
Downward
Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
Setting the louver lock
1
Push and hold the
button (right side of
the button) for at least 4 seconds while running
is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the
button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to display the
number of the louver to fix its direction.
The selected louver swings.
4
Push the TIME
buttons to select the
direction of the louver you do not want to swing.
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the
button to confirm the setting.
When the setting is confirmed, the
mark lights up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
6
Push the
button to finish the setting.
(3)
(2)
(1)
(1)
(4)
(2)
(3)
(2)
(3)
(4)
(1)
(4)
(3)
(2)
(1)
(4)
UNIT LOUVER
UNIT LOUVER
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
(1)
0001
(2)
0002
(3)
0003
(5)
0005
(4)
0004
1FAN_OM_EHV0000101-01.book Page 11 Thursday, September 13, 2018 5:10 PM
