Toshiba ES9455 MFP, Copying Manual, Page: 44 / 208

2 HOW TO MAKE COPIES
42 Copying from MPT
The operating procedure for copying from MPT differs depending on the paper size to be used. See the table below for the
operating procedure of each size.
y Copying from MPT stops when the paper placed on the MPT runs out during copying, even if the paper of the same
size is in any of the trays. Copying restarts when paper is supplied to the MPT.
y When copying from MPT has been completed, the [RESET] button on the control panel blinks. Press this button to
switch Copying from MPT to normal copying using the trays.
(Even if you do not press the [RESET] button, the Copying from MPT mode will be cleared when the automatic
function clear mode kicks in after a specified period of time.)
„
Copying from MPT on standard size paper
‰ Copying on A3, A4, B4 and B5 size paper (in equipment other than for North
America) / LD, LT, LG and ST-R size paper (in equipment for North America)
1
Place the original(s).
y The height of the paper must not exceed the indicator on the side guides.
y When you use more than one sheet of paper, fan the sheets well before placing them on the MPT. Be
careful not to cut your fingers when fanning.
y Do not push paper into the entrance of the MPT. This could cause a paper misfeed.
Paper size Procedure
Standard size
Other than North America:
A3, A4, B4, B5
North America: LD, LT, LG,
ST-R P.42 “Copying on A3, A4, B4 and B5 size paper (in equipment other than for
North America) / LD, LT, LG and ST-R size paper (in equipment for North America)”
Other than the above P.46 “Copying on other than the above standard sizes of paper”
Envelope P.49 “Copying on an envelope”
Others (Non-standard sizes) P.52 “Copying from MPT on non-standard size paper”
2
Move the paper holding lever toward the outside.
Place paper with its copy side down on the MPT.
3
Align the side guides to the paper length. Move the
paper holding lever toward the equipment.
When paper is placed, the menu for copying from MPT appears.
2
1