LQ500
6
• Moving average function:
In order to keep the average density (%TS,
consistency) output, or in order to suppress the
deflection width of the output. It helps for density
(%TS, consistency) control.
<Specification>
Enable to determine a number from 1 to 999.
• Change-rate limit function:
In order to reject the transient density (%TS,
consistency) output as noises, or a sudden
variation in the output according to intrusion by
bubbles, etc....
<Specification>
Allowable rate of change limit: 0.00 to 9.99%TS
Enable to determine a number from 0 to 99.
• Additive correction function:
Capable of handling up to ten brands, this
function performs the sensitivity correction
appropriate to the additives type and compound
ratio in accordance with the parameters that are
registered in advance.
• Password function:
This function is used to limit access to changing
parameters that affect measured data by means of
a password.
• Number of Rotation N fixed function:
This function is used to fix the number of angle
rotation N when the external synchronized
operation starts.
(LQ500 measure the phase of microwave, and
calculate the density/%TS from the phase changes.
Because the phase is limited from 0 degree to 360
degrees, LQ500 use the rotation N when the phase
is over 360degree. But the range of density is wide
over the 360 degree, LQ500 may not know the
number of the rotation N when the pump starts. If
the density is constant when the pump starts,
LQ500 can set the number of rotation N, and
measure the correct density(%TS, consistency).
Arrestor:
Arrestors are installed in the LQ500 current output
(4-20mAdc) and AC power lines.
Operation panel and Display:
Used to check data or change various settings.
Operation switches: 5 switches.
Display: 4-line, 20-character VFD(dot-matrix
)
Power supply:
100 to 240Vac 50/60Hz (Allowable voltage: 85 to
264Vac)
Note1: An additional power supply is required when
choosing an optional environmental temperature
specification type (-20 to 50 deg.C).
Refer to the section of Environmental conditions in
detail.
Power consumption:
Approx. 25VA (100Vac), Approx. 35VA (240Vac)
Housing material: Steel plate
Coating: Polyurethane
MTBF: 135.8 months under 25 deg. C (77 deg. F)
based on MLL-HDBK-217F
