32
EPG Timer (DTV mode only)
You can choose whether or not the screen switches on when the timer event begins - see page 23 (Rec screen status (LCD
Power on/off)). This is so that if you are using the timer to make a recording to your VCR or other device, the TV screen will not
switch on unless you want it to.
If you try to switch to another channel while a timer event is in progress, the following message will appear: ‘Warning: Changing
the channel will interrupt your event timer. Are you sure you want to proceed? Yes/No”. Select “Yes” or “No” according to your
wishes.
Notes:
• When the EPG Timer
starts, the message
‘Event Timer Started’
will appear.
• If the EPG Timer starts
when it is already switched
on, it will start at the exact
time that is set. If it starts
from the standby mode, it
will begin 20 seconds in
advance of the stated
time.
• You cannot hasten the
start time from the original
start time of the Event.
• You cannot set with the
same date and time of
another Event.
• Press the
Yellow/PLAY
MODE
button to change
the start time of the event.
• Press the
Blue/SLOW
button to change the time
duration of the event.
• When in power-off-
condition, EPG Timer
cannot be activated.
• If the EPG Timer begins
during standby mode
without screen display, the
Power indicator on the unit
will be lit in orange. This is
to indicate that an EPG
Timer event has begun in
standby mode. However,
if it begins during the
standby mode with a
screen display, the Power
indicator on the unit will
light up green.
1
Press
GUIDE
to display the EPG menu.
2
Press
/
to highlight the programme you want to set as a timer event, then
press
ENTER/CH LIST
.
Notes:
• If you select an event which has already started, the selected programme will be
displayed on the screen, as you cannot set the timer for a programme which has already
started.
• To display the stored timer events, press
GUIDE
twice. The Event Timer menu (see
step 4 below) will appear. You can also delete or change the frequency (Once/Daily/
Weekly) of the stored timer events (but please note that you cannot edit the time details
that have been set from the EPG).
3
A confirmation banner will be displayed.
Press
to select “Yes” or “No”, then press
ENTER/CH LIST
(the selected option
is shown in blue).
4
The Event Timer menu will appear.
Press the
Red/SLOW
button to set the
Timer mode for a selected event.
5
The Timer mode specifies the frequency of
Timer wake-up which can be set as Once,
Daily or Weekly.
Press
ENTER/CH LIST
to save the
selected Timer mode.
Note:
To delete a timer event, select the specified
event, then press the
Green/PAUSE
button.
6
To return to the EPG menu, press
ENTER/CH LIST
.
To clear the menu screen, press
EXIT/CANCEL
.
/
/
/
