Connections
Connections
18
Ampli
fi
er equipped with a
Digital audio input
To COAXIAL
type digital
audio input
75
Ω
coaxial cable (not supplied)
To COAXIAL DIGITAL
AUDIO OUT
MPEG2 sound
You can enjoy motion picture and live concert DVD video discs encoded via the MPEG2 recording system with dynamic
realistic sound by connecting an ampli
fi
er equipped with an MPEG2 audio decoder or MPEG2 audio processor.
Connecting to an ampli
fi
er equipped with an MPEG audio decoder
Connecting to an ampli
fi
er equipped with a digital audio input
2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by connecting an ampli
fi
er equipped with a digital audio input and
speaker system (right and left front speakers).
Note:
PCM audio is limited to DVD or CD playback.
Notes:
• DO NOT connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the AC-3 RF input of a Dolby Digital Receiver.
This input on your A/V Receiver is reserved for Laserdisc use only and is incompatible with the COAXIAL DIGITAL AUDIO
OUT jack of the TV/DVD.
• Connect the COAXIAL DIGITAL AUDIO OUT jack of the TV/DVD to the “COAXIAL” input of a Receiver or Processor.
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the TV/DVD to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
• The output sound of the TV/DVD has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level.
Otherwise, the speakers and your hearing may be damaged by a sudden high volume sound.
• Turn off the ampli
fi
er before you connect or disconnect the TV/DVD’s power cord. If you leave the ampli
fi
er’s power on, the
speakers may be damaged.
Ampli
fi
er equipped with an
MPEG2 audio decoder
To COAXIAL
type digital
audio input
75
Ω
coaxial cable (not supplied)
Left side (LINE 1 IN)
To COAXIAL DIGITAL
AUDIO OUT
Connecting to optional equipment (Continued)/Power source
: Front speaker
: Rear speaker
: Sub woofer
: Center speaker
: Signal
fl
ow
* This section uses the following reference mark.
Power source
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug
into a standard 120V 60Hz polarized AC outlet.
Notes:
• Never connect the AC line cord plug to other than the speci
fi
ed voltage (120V 60Hz).
Use the attached power cord only.
• If the polarized AC cord does not
fi
t into a non-polarized AC outlet, do not attempt to
fi
le or cut the blade. It is the user’s responsibility to have an electrician replace the
obsolete
outlet.
• If you cause a static discharge when touching the unit and the unit fails to function, simply unplug
the unit from the AC outlet and plug it back in. The unit should return to normal operation.
• If the AC cord plug is plugged in for the
fi
rst time, wait for approx. 5 seconds before
pressing the POWER button.
AC Outlet
Wider Hole
and Blade
Polarized AC Cord Plug
(One blade is wider than the other.)
Left side (LINE 1 IN)
Book 5Z0-01.indb 18
Book 5Z0-01.indb 18
9/11/2549 16:15:04
9/11/2549 16:15:04
