Mar. 1998 © TOSHIBA
18 - 13
1550/1560 UNPACKING PROCEDURE
B. Installation Procedure
1. Docking the MY-1004 with the copier
(1) Place the MY-1004 on the copier stand.
(2) Using two people, lift the copier and place
it slowly onto the MY-1004 so that the copi-
er’s cassette guide holes (not shown in the
diagram) are aligned with the MY-1004’s
positioning pins.
Notes: 1 When docking the MY-1004 with the
copier, aligning the front and right-
hand surfaces of the copier with
those of the MY-1004, respectively,
will make the installation easier.
2 Before the copier and the MY-1004
are fastened with screws (4 places),
do not move or carry them to another
place.
2. Removing the covers
(1) Remove the rear cover of the MY-1004 (2
screws).
(2) Remove the rear cover of the copier (2
screws).
(3) Remove the lower feed side cover of the
copier (2 screws).
Summary of Contents for 1550
