-60-
7.3.6
Post-print Stop Position Setting (Stop Position)
When back feed restriction is enabled (ON), printing is disabled on a label located between the head and the cutter
during next printing after an issue (of one or more labels) since no back feed is performed. To prevent such waste, stop
position setting is performed.
* For details, refer to the External Equipment Interface Specification (JEA
－
03580).
・
CUT
Stop at the cut position
・
HEAD
Stop at the head position
Default value: CUT (Stop at the cut position)
*Support mode (o
：
valid
、
x
：
invalid
）
TPCL, TPCL1,
LABEL
C Mode
ESC/POS
Z Mode
o
o
o
o
<Commentary>
Both settings (stop at the cut position/stop at the head position) have advantages and disadvantages.
[Stop at the cut position]
Advantage:
Labels can be cut with the cutter after printing is complete.
Disadvantage: A label is wasted during next printing after printing is complete.
[Stop at the head position]
Advantage:
Printing can be continued without wasting labels after printing is complete.
Disadvantage: Since a gap between labels is not located at the cutter position after printing is complete,
cutting is disabled until the [FEED] key is pressed.
Cutting is not performed easily on labels after printing is complete. If cutting is performed
forcibly, the labels may be dislodged, causing printing to be misaligned.