-58-
7.3.1
CMD Setting
This setting selects print mode.
TPCL
TPCL1
LABEL
C Mode
ESC/POS
Z Mode
Default value: TPCL
*Support mode (o
：
valid
、
x
：
invalid
）
TPCL, TPCL1,
LABEL
C Mode
ESC/POS
Z Mode
o
o
o
o
7.3.2
Head Division Setting (HEAD DIV)
When a printing ratio per line is high, the value of this setting is changed to prevent print tone from becoming lighter.
AUTO
Automatic selection from 2, 3, or 4 division
AUTO1
Automatic selection from none, 2 ,3, or 4 division (Print quality oriented)
AUTO2
Automatic selection from none, 2 or 3 division (Print speed oriented)
Default value: AUTO1 (none, 2 division, 3 division or 4 division)
<Commentary>
If it uses normal battery, available conditions of AUTO2 is:
- Ambient temperature is over 10 degree.
- Battery level is over 4.
- Label pitch is less than 63mm.
And the movement is: after every 10 continuous prints, it stops 3 sec.
*Support mode (o
：
valid
、
x
：
invalid
）
TPCL, TPCL1,
LABEL
C Mode
ESC/POS
Z Mode
o
o
o
o
7.3.3
Head Output Division Command Parameter Setting (Head DIV CMD)
This setting enables or disables the head output division parameter of AY command.
OFF
Head output division parameter of AY command is disabled.
ON
Head output division parameter of AY command is enabled.
Default value: ON (Head output division parameter of AY command is enabled).
*Support mode (o
：
valid
、
x
：
invalid
）
TPCL, TPCL1,
LABEL
C Mode
ESC/POS
Z Mode
o
x
x
x