Autoped/ M10 APPENDIX rev 0 (09221 DRAFT)
A-9
I.2 INSTALLATION: LEFTHAND OPERATOR FOR HEADERS LESS THA
N 4” IN HEIGHT
STEP 1
Use StiffenerPlate for Lefthand (LH) installation
STEP 2
Align
“
X
”
to corner of left hinge jamb and bottom of
header
STEP 3
Center-punch pilot holes 1,2,3
STEP 4
Drill 1/16” pilot holes 1,2,3
STEP 5
Fasten
1
StiffenerPlate through holes 1,2,3
STEP 6
Mount
2
operator Chassis to StiffenerPlate
STEP 7
Mount
3
Motor-Drive assembly to operator Chassis
STEP 8
Refer back to AUTOPED Installation Manual, Section I.5
to continue installation of the Swing Arm assembly
1
Type, size and material of fasteners by installer
2
Use screws NF 7/16 x 20 x 3/4 included in kit to mount
3
Use screws M6 x 1.0 x 12 included in kit to mount
Summary of Contents for AUTOPED 10
