TORXUN AUTOPED 10, Manual, Page: 22 / 43

Autoped/ M10 APPENDIX rev 0 (09221 DRAFT)
A-22
Device Unit type Default Value Description Device
Rod Full and low STD-PH STD-PH Outswing
arm and
Arm-Shoe Push function
Motor cable connector: X=orange
SLI-PL Inswing arm
with track
and roller Pull function
Motor cable connector: Y=Green
SLI-PH Outswing
with inswing
track and
roller Push function
Motor cable connector: X=orange
Rod Low energy STD-PH

If panic breakout latch is installed and the motor is plugged in backwards or the
wrong arms are chosen during programming, there is a possibility the Door/Gate
panel can burst open unexpectedly towards the installer once TEACH mode is
initiated.

Teach must be activated after this setting has been changed.
Inverse Low energy Off Off-
On In the event of a power failure/error, the Door/Gate panel is opened by spring
power from any position (unless it has been locked). The position of the motor
connector is reversed regarding the standard drive unit.
Teach must be activated after this setting has been changed.
dAxis Low energy 7in 2-
25in Distance between center line of the door hinges and the mounting surface of the
operating assembly. dAxis is an approximate value. Depending on the
installation situation, dAxis may have to be estimated.
Teach must be activated after this setting has been changed.
IV.7 CONFIGURATION MENU OPTIONS AND DEFINITIONS
Device Unit type Default Description
APuGO Off Off, 2°-10° Triggering angle for Push and Go (angle Push and Go)
ASES 95° 45°-95° Lock out angle:
Angle at which the swing side Door/Gate panel mounted sensor is ignored just
before open/
If Ao is changed, ASES is automatically set to Ao.
ASER 0° 0°-60° Lock out angle: angle at which push side of the Door/Gate panel sensor is
ignored just before closing.
SESClo Inactive Active Sensor mounted on swing side of Door/Gate is activated or inactivated during
closing cycle
Inactive