TORXUN AUTOPED 10, Manual, Page: 30 / 43

Autoped/ M10 APPENDIX rev 0 (09221 DRAFT)
A-30
Error No Description Cause Elimination Checking time Reaction
E22 01 NOT test NOT input on 24v Check the jumper NOT. Check the
cabling of the NOT Permanent H
02 Malfunction Restart the control unit SW update
necessary After power up
E30 01 30v error 30v too low
Main’s failure, overload motor.
Check 115vac line. Replace
hardware
Permanent A
02 30v too high
03 Error upon switching on After power up
E31 01 24v general Error upon switching on Overload, short circuit of the 24v
inputs (without electric lock, safety
sensors) After power up A (restart
after 10
seconds)
02 Over-resp, under-voltage permanent
E32 01 24v safety Over-resp, under voltage Overload, short circuit safety
sensors
E33 01 24v E-lock Error: over-resp under
voltage Overload, short circuit electric lock
02 Premonition: over-resp
under voltage w
E34 01 24v CAN Over resp under voltage Overload, short circuit external
power supply CAN
E60 00 Relay PCB 0 Optional PCB has been
removed, its address
changed or became
defective Check if the option is provided.
If defective: replace or remove
from configuration. Permanent W
10 Relay PCB 1 W
20 Radio PCB W
30 Fire
Protection A
E50 01-
99
System error Unexpected hardware or
software event Switch the drive unit Off/On.
Carry out a Factory Reset, Carry
out a software update, inform the
manufacturer permanent W or H or F
E51
E52
E70 XX CAN bus
setting
CAN address XX existing
twice Correctly define the role of the
closing sequence or the interlock
function Permanent W
E71 01 CAN
connection No CAN connection Plug in, check, or replace the CAN
cable
Check if all the CAN participants
are switched on Permanent W