Torrot Motocross ONE, User Manual

Page: 35 / 58

29
One of the points that differentiates this vehicle from others is that its batteries are easy to remove and
transport to charge them wherever you like. Moreover, this option allows you to have more than one battery
so that you can change it when it is depleted. Thus, you will not have to wait to charge the battery to continue
using the motorcycle.
Never remove the battery when the motorcycle is switched on.
Follow the following steps to extract and charge the battery:
1. Ensure that the motorcycle is switched off. See the section Stopping the
vehicle.
2. Loosen the Velcro® strap that fastens the battery (1).
3. Pull the battery out from the rear of the motorcycle. Pay special attention
when handling the battery, it is a component with a considerable weight,
try to remove it carefully and avoid hitting it.
4. Remove the protective rubber cap from the battery connector (2).
5. Connect the charger cable with its three-pin connection to the battery (3).
6. Plug the cable (4) into the charger and then the other end into the 100-240V house
mains (5). You will see that LED 2 on the charger turns red to indicate that the battery
is charging.
LED 2 LED 1
Charger switched on Green Red
Battery charging Red Red
Battery fully charged Green Red
The LED 2 will turn green when the battery is fully charged. It will take about 4 hours to fully charge in the
case of a series ONE battery, and 5.5 hours for a full charge in the case of a KIDS TWO series.
To lengthen the lifetime of your battery, do not charge it only halfway. Wait until the LED 2 is green!
After charging the battery, follow the following steps to install it in the vehicle:
1. Unplug the charger from the socket (5) and, only then, disconnect the battery charger (3), fit the
battery connector’s protective rubber cap (2).
2. Ensure that the motorcycle is switched off. See the section Stopping the vehicle.
3. Ensure that the battery compartment, its connector and the battery itself are completely dry.
4. Slide the battery inside through the rear of the motorcycle. Remember to insert the battery properly
and in the correct direction. Pay special attention when handling the battery, it is a component with
a considerable weight, try to insert it carefully and avoid hitting it.
5. Tighten the Velcro® strap to fasten the battery (1).