80
Deutsch
English
5.3.4 Error message / Troubleshooting
• Repairs may only be carried out by authorised Torqeedo Service Centers.
Any attempts of unauthorized repairs or modification will entail loss of
warranty.
• Please note that opening the pylon and/or the inner shaft head cover
will entail loss of warranty.
• In warranty cases please follow the warranty instructions at the top of
the operating manual.
Display
Cause
What to do
E02
Stator over-temperature
(motor overheating)
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E05
Motor/propeller blocked
Switch main switch to ”OFF” position, then remove
blockage and turn propeller one revolution by hand.
Reconnect motor cable.
E06
Voltage in the motor too
low
Low battery charging status. Motor can potentially be used
again slowly from the stop position.
E07
Motor overcurrent
Continue at low output.
E08
Circuit board overheating
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E21
Tiller calibration defective
• Re-calibrate: Press “cal” button for 10 seconds.
• The display shows “cal up”: Press tiller forward to full
gas then press the “cal” button.
• The display shows “cal stp”: Return tiller to central posi-
tion then press the “cal” button.
• The display shows “cal dn”: Press tiller backward to full
gas then press the “cal” button.
E22
Magnetic sensor defective
Re-calibrate (refer to E21)
E23
Value range false
Re-calibrate (refer to E21)
E30
Motor communication
error
Check the motor cable’s plug-in connection. Check the
motor cable for damage.
1.
2.
3.
Turn remote throttle control/ tiller
to stop position
Remove magnetic
on/off key
Switch main switch of cable
set to OFF respectively “‚0“
position
