Toro TX Platform, Installation Instructions Manual, Page: 6 / 12

3
Installing the
Counterweight (TX 500
Series Traction Units Only)
Parts needed for this procedure:
1 Counterweight
4 Bolt (1/2 x 1-1/4 inches)
4 Washer
Procedure
If you are installing this kit on a TX 500 series traction
unit, install the counterweight to the front of the
traction unit using 4 bolts (1/2 x 1-1/4 inches) and
washers (
Figure 6 ). Apply a locking compound to the
threads of the bolts before installing them. Torque the
bolts to 73 to 89 N∙m (54 to 66 ft-lb).
g004782
Figure 6
1. Bolt (1/2 x 1-1/4 inches) 3. Counterweight
2. Washer 4. Mounting holes
4
Installing the Decal
No Parts Required
Procedure
1. Clean the area behind the traction control
(
Figure 7 ) so that there is not dirt or grease on it.
g004511
Figure 7
1. Decal position
2. Remove the backing from the decal and secure
it in place (
Figure 7 ).
Note:
To keep from getting bubbles under the
decal, press it down in the center first and rub it
outward toward the edges.
6