Toro TX Platform, Installation Instructions Manual, Page: 3 / 12

1
Preparing the Traction Unit
No Parts Required
Procedure
1. Stop the engine, lower the loader arms, set the
parking brake, and remove the key.
2. Wash all dirt and debris from the traction unit.
3. If you are installing this kit on a TX 400 series
traction unit, remove the counterweights and
their fasteners from the rear of the traction unit
and store them in a safe location (
Figure 1 ).
g004399
Figure 1
Left counterweight not shown.
1. Counterweight 2. Fasteners
2
Installing the Platform
Parts needed for this procedure:
1 Platform assembly
4 Bolt (1/2 x 1-1/2 inches)
4 Flange-head nut (1/2 inch)
Procedure
1. Check and tighten the bottom 2 bolts securing
the lower rear panel to the frame (
Figure 2 ).
g004398
Figure 2
1. Bolts 2. Rear panel ( do not
remove )
2. One at a time, remove and discard the 4 bolts
and nuts securing sides of the lower rear panel
to the frame, replacing each with a new bolt (1/2
x 1-1/2 inches) installed from the front to hold
the space as pressure is released on the rear
panel (
Figure 3 ).
Important:
Do not remove the rear panel
( Figure 2 ).
3