Toro TX Platform, Installation Instructions Manual, Page: 4 / 12

g004400
Figure 3
Left side not shown.
1. Bolt (2 on each side) 2. Flange-head nut (2 on each side) 3. Bolt (1/2 x 1-1/2 inches)
Note:
Figure 3 shows a TX 500 series traction
unit. If you have a TX 400 series traction unit
it will look slightly different, but it is configured
similarly.
3. Grab the platform handle and pull up on it to
extend the platform (
Figure 4 ).
g004401
Figure 4
1. Platform assembly 3. Mounting bracket
2. Handle 4. Loosen these bolts
4. By hand, loosen, but do not remove, the 4 bolts
and nuts securing the platform assembly to the
mounting brackets (
Figure 4 ).
5. Install the mounting brackets ( Figure 5 ) onto the
4 bolts (1/2 x 1-1/2 inches) you inserted earlier,
and secure them with 4 flange-head nuts (1/2
inch).
4