Toro TimeCutter ZS 3200S, Operator'S Manual

Page: 24 / 56

9. Lower the grass deflector over the discharge opening
Important:
Ensure that the mower has a hinged
grass deflector that disperses clippings to the side
and down toward the turf, while in side-discharge
mode.
Installing the Discharge Cover for
Mulching
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Ensure the parking brake is engaged, stop the engine,
remove the key, and wait for all the moving parts to
stop before leaving the operating position.
3. Remove the cutoff baffle from the mower deck ( Figure
24 ).
4. Lift the grass deflector and slide the tabs on top of the
discharge cover under the grass deflector retaining rod.
5. Rotate the discharge cover down over the opening, and
onto the lower lip of the mower (
Figure 25 ).
Figure 25
1. Discharge cover
3. Bolt (1/4 x 2-1/2 inches)
2. Cap nut (1/4 inch)
6. Secure the discharge cover to the lower lip of the
mower with 2 bolts (1/4 x 2-1/2 inches) and 2 cap nuts
(1/4 inch) as shown in
Figure 25 .
Note:
Do not overtighten the nuts; this could distort
the cover and cause blade contact.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions. Knowing this information could
help you, your family, pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow
moving vehicle emblem is dangerous and can lead
to accidents causing personal injury.
Do not drive machine on a public street or roadway.
To transport the machine:
1. If using a trailer, connect it to the towing vehicle and
connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Stop the engine, remove the key, set the brake, and
close the fuel valve.
5. Tie down the machine near the front caster wheels and
the rear bumper (
Figure 26 ).
Figure 26
24