G017459
Figure 7
1.
The oil level is at its
maximum.
3.
The oil level is too
low—add oil to the
crankcase.
2.
The oil level is too
high—remove oil from
the crankcase.
3.
Slowly
pour oil into the oil fill hole, wait a few
minutes, and check the oil level on the dipstick by
wiping the dipstick clean and then inserting,
but not
screwing in,
the oil fill cap into the hole (Figure 7).
Note:
Fill the engine crankcase with oil until the
dipstick indicates that the engine oil level is correct
as shown in Figure 7. If you overfill the engine with
oil, remove the excess oil as directed in Changing
the Engine Oil.
4. Install the dipstick and hand tighten it securely.
Important:
Change the engine oil after the first
5 operating hours
; change it yearly thereafter.
Refer to Changing the Engine Oil.
Product Overview
G017646
1
2
3
4
5 6
7
8
9
10
11
12
13
Figure 8
1.
Cutting height lever (4)
8.
Blade control bar
2.
Spark plug
9.
Upper handle
3.
Recoil start handle
10.
Engine stop switch
4.
Oil fill/Dipstick (not shown) 11.
Grass bag
5.
Fuel tank cap
12.
Washout port
6.
Discharge deflector
13.
Air filter
7.
Control bar lock
Figure 9
1.
Grass bag
3.
Rear discharge plug
(installed)
2.
Side discharge chute
7
Summary of Contents for Super Recycler 20383
Page 22: ...Notes 22 ...
Page 23: ...Notes 23 ...
