Setup
Important:
Remove and discard the protective
plastic sheet that covers the engine.
1
Installing the Blade Control
Bar
No Parts Required
Procedure
Install the blade control bar into the upper handle
(Figure 3).
Figure 3
2
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
•
Do not damage the cables when assembling and
unfolding the handle.
•
Ensure that the cables are routed to the outside
of the handle.
•
If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the mower housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height in the Operation section.
2. Attach the handle ends to the mower housing with
2 washers and 2 handle bolts (Figure 4),
but do not
tighten the handle bolts.
G017457
Figure 4
1.
Washer
3.
Handle end
2.
Handle bolt
Important:
Route the cables to the
outside
of
the handle (Figure 4).
3. Rotate the handle rearward (Figure 5).
5
Summary of Contents for Super Recycler 20383
Page 22: ...Notes 22 ...
Page 23: ...Notes 23 ...
