Preparing for Maintenance
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the spark plug wire from the spark plug
(Figure 35) before performing any maintenance
procedure.
G017466
1
Figure 35
1.
Spark-plug wire
3. After performing the maintenance procedure(s),
connect the spark plug wire to the spark plug.
Important:
Before tipping the mower to change
the oil or replace the blade, allow the fuel tank
to run dry through normal usage. If you must
tip the mower prior to running out of fuel, use a
hand fuel pump to remove the fuel. Always tip
the mower onto its side with the air filter up.
WARNING
Tipping the mower may cause the fuel to leak.
Gasoline is flammable, explosive and can cause
personal injury.
Run the engine dry or remove the gasoline with
a hand pump; never siphon.
Replacing the Air Cleaner
Service Interval:
Yearly
1. Press down on the latch tabs on top of the air cleaner
cover (Figure 36).
Figure 36
1.
Latch tabs
3.
Foam pre-filter
2.
Paper air filter
2. Open the cover.
3. Remove the paper air filter and the foam pre-filter
(Figure 36).
4. Inspect the foam pre-filter, and replace it if it is
damaged or excessively dirty.
5. Inspect the paper air filter.
A. If the paper air filter is damaged or is wet with oil
or fuel, replace it.
B. If the paper air filter is dirty, tap it on a hard
surface several times or blow compressed air less
than 30 psi (207 kPa) through the side of the
filter that faces the engine.
Note:
Do not brush the dirt off the filter;
brushing forces dirt into the fibers.
6. Remove dirt from the air cleaner body and cover
using a moist rag (to trap the dirt and keep it from
falling into the engine).
Do not wipe dirt into the
air duct.
7. Insert the foam pre-filter and the paper air filter into
the air cleaner.
8. Install the cover.
17
Summary of Contents for Super Recycler 20383
Page 22: ...Notes 22 ...
Page 23: ...Notes 23 ...
