Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Lower the cutting units to the ground, set the
parking brake and remove the key from the
ignition switch before servicing or making
adjustments to the machine.
Checking the Engine Oil Level
The engine is shipped with oil in the crankcase;
however, the oil level must be checked before and after
the engine is first started.
Crankcase capacity for model 5210 is approximately
3.5 qt. (3.3 l) with the filter. Crankcase capacity for
models 5410, 5510 and 5610 is approximately 5.5 qt.
(5.2 l) with the filter.
Use high-quality engine oil that meets the following
specifications:
•
API Classification Level Required: CH-4, CI-4 or
higher
•
Preferred oil: SAE 15W-40 (above 0 degrees F)
•
Alternate oil: SAE 10W-30 or 5W-30 (all
temperatures)
Toro Premium Engine oil is available from your
distributor in either 15W-40 or 10W-30 viscosity.
1. Park the machine on a level surface, stop the engine,
set the parking brake and remove the key from the
ignition switch.
2. Open the hood.
3. Remove the dipstick, wipe it clean, and install it
Figure 31
1.
Dipstick
4. Remove dipstick and check oil level on dipstick.
The oil level should be up to the Full mark .
5. If the oil level is below the Full mark, remove the
fill cap (Figure 32) and add oil until level reaches
the Full mark on dipstick.
Figure 32
1.
Oil fill cap
Do not overfill.
Important:
Be sure to keep the engine oil level
between the upper and lower limits on the oil
27
