Figure 4
1.
Counter weight
5. All the cutting units are shipped with the turf
compensation spring mounted to the right side of
the cutting unit. The turf compensation spring
must be mounted to the same side of the cutting
unit as the reel drive motor. Reposition the turf
compensation as follows:
A. Remove the 2 carriage bolts and nuts securing
the rod bracket to the cutting unit tabs (Figure 5).
Figure 5
1.
Turf compensation spring
3.
Spring tube
2.
Rod bracket
B. Remove the flange nut securing the spring tube
capscrew to the carrier frame tab (Figure 5)
Remove the assembly.
C. Mount the spring tube capscrew to the opposite
tab on the carrier frame and secure with the
flange nut. The capscrew head is to be positioned
to the outer side of the tab as shown in Figure 6.
Figure 6
1.
Opposite carrier frame tab
2.
Rod bracket
D. Mount the rod bracket to the cutting unit tabs
with the carriage bolts and nuts (Figure 6). Also,
on the #4 cutting unit, mount the left hand hose
guide to the front of the cutting unit tabs when
reinstalling the rod bracket (Figure 7).
Note:
On the #5 cutting unit, use the rod
bracket mounting nuts to install the right hand
hose guide to the front of the cutting unit tabs.
Figure 7
1.
Hose guide (Left hand
shown)
3.
Carriage bolts
2.
Rod bracket
4.
Nuts
Note:
When installing or removing the cutting
units, make sure the hairpin cotter is installed
in the spring rod hole next to the rod bracket.
Otherwise, the hairpin cotter must be installed in
the hole in the end of the rod.
6. Lower all the lift arms completely.
7. Remove the snapper pin and the cap from the lift
arm pivot yoke (Figure 8).
14
