Toro Reelmaster 2000-D, Service Manual

Page: 191 / 208

Reelmaster 2000–D Page 7 – 19 Cutting Units
Fixed Side Plate Installation
1. Remove pop rivets and rear height–of–cut plates
from both sides of the cutting unit (Fig. 16).
2. Remove lock nuts, cap screws, washers, and both
links from the cutting unit (Fig. 16).
3. Align fixed side plate with holes on the cutting unit
(Fig. 17).
4. Attach fixed side plate to the cutting unit with cap
screws, washers, and flanged lock nuts (Fig. 17).
5. Tighten lock nuts and cap screws.
6. Fasten new height–of–cut plate to the cutting unit
with pop rivets (Fig. 17).
7. Repeat steps 1 through 6 on the other side of the cut-
ting unit.
1. Pop rivet
2. Height–of–cut plate
3. Lock nut
4. Cap screw
5. Washer
6. Link
4
6
1
2
5
3
Figure 16
1. Fixed side plate
2. Cap
screw
3. Washers
4. Flanged lock nut
5. Height–of–cut
plate
6. Pop rivet
1
5
6
3
2
4
Figure 17
Cutting Units