Toro Reelmaster 2000-D, Service Manual

Page: 167 / 208

Reelmaster 2000–D Page 6 – 11 Chassis
Suspension Seat
1. Plate
2. Rivet
3. Screw
4. Wear parts kit (incl. 8 thru 11)
5. Tension spring set
6. Handle
grip
7. Adjusting lever
8. Cover
9. Bumper
10. Bushing
11. Pad
12. Backrest cushion
13. Hex head machine screw
14. Arm rests
15. Bottom cushion
16. Adjusting rail (LH)
17. Screw
18. Washer
19. Nut
20. Swing arm assembly (incl. 28 & 42)
21. Adjusting rail (RH)
22. Bottom trim
23. Seat frame
24. Screw
25. Seat switch (incl. 24, 26, & 27)
26. Spring washer
27. Nut
28. Back plate pivot
29. Threaded clevis
30. Nut 31. Washer
32. Backrest trim
33. Tension spring set
34. Spindle adjuster (incl. 29 thru
35. Screw
36. Cover
37. Clamp
38. Shock absorber
39. Nut
40. Washer
41. Bushing kit (incl. 39 & 40)
42. Backrest plate
43. Hex flange nut
44. Cap screw
Figure 6
31
32
33
34
35
36
37
38
39 40
41
42
1
2
3 4
5 6
7
8
9
10
16
17
18
19
20
21
22
23
24
25
26
27
28
29 30
11
12
13
14
15
5
43
44
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove four cap screws and lock nuts securing the
seat to the frame.
3. Disconnect electrical connector from the seat switch.
Separate seat from the frame.
4. Remove seat parts as necessary to make repairs us-
ing Figure 6 as a guide.
Installation
1. Install any new seat parts using Figure 6 as a guide.
2. Position seat to the machine frame.
3. Connect electrical connector to the seat switch.
4. Secure seat to the frame with cap screws and lock
nuts.
Chassis