Toro Reelmaster 2000-D, Service Manual, Page: 147 / 208

Reelmaster 2000–D
Page 5 – 21
Electrical System
Parking Brake Switch
The parking brake switch is a normally open proximity
switch that is mounted on a bracket at the base of the
parking brake lever (Fig. 23). The parking brake lever is
used as the sensing plate.
When the parking brake is engaged, the brake lever is
moved away from the brake switch and the switch
opens. This open switch prevents the cutting units from
operating.
The Standard Control Module monitors the operation of
the parking brake switch. If the ignition switch is in the
ON position and the parking brake is not applied, the
Module brake off input LED should be illuminated.
Parking Brake Switch Test
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Disconnect parking brake switch from machine wir-
ing harness.
3. Check the continuity of the switch by connecting a
multimeter (ohms setting) across the switch connector
terminals.
4. With the parking brake disengaged, there should be
continuity across the switch terminals.
5. Apply the parking brake. There should be no continu-
ity across the switch terminals.
6. Replace switch as needed. Reconnect switch.
1. Parking brake lever 2. Brake switch
Figure 23
2
1
Electrical
System