Toro ProCore 1298, Operator'S Manual

Page: 9 / 32

1
Inspecting the Machine
No Parts Required
Procedure
ProCore 864
Use the following list as a reference:
•
30 PTO horsepower minimum when used in light to
normal conditions (sandy to sandy/loam soils with
average compaction)
•
35 PTO horsepower minimum when used in normal to
heavy conditions (heavy loam, clay, and rocky soils with
above average compaction)
•
Category I or II 3-point hitch, rated to lift at least a 714
kg (1575 lb) implement
•
540 rpm tractor PTO˙
•
Adequate front-end weight (ballast)
•
Correct tire pressure
CAUTION
Do not exceed the maximum or minimum
tractor tire inflation pressures as recommended
by tire manufacturer.
ProCore 1298
Use the following list as a reference:
•
45 PTO horsepower minimum when used in light to
normal conditions (sandy to sandy/loam soils with
average compaction)
•
50 PTO horsepower minimum when used in normal to
heavy conditions (heavy loam, clay, and rocky soils with
above average compaction)
•
Category II 3 point hitch, rated to lift at least a 1043 kg
(2300 lb) implement
•
540 rpm tractor PTO˙
•
Adequate front-end weight (ballast)
•
Correct tire pressure
CAUTION
Do not exceed the maximum or minimum
tractor tire inflation pressures as recommended
by tire manufacturer.
Tractor Components ( Figure 4 )
g007332
Figure 4
1. Lower link arm 3. PTO shaft
2. Upper link arm 4. Sway link
Ballast Requirements
WARNING
Mounting the ProCore aerator to the rear of the
tractor will decrease the weight on the front axle.
Failure to add required ballast may result in an
accident and severe injury or death.
• To ensure adequate steering control and stability
it may be necessary to add ballast to the front
of the tractor.
• Refer to the tractor operator's manual for ballast
requirements.
2
Connecting the Lower Link
Arms
Parts needed for this procedure:
2 Lynch pin
Procedure
1. Ensure that the aerator is positioned on a flat, level
surface for installation.
9