Toro ProCore 1298, Operator'S Manual

Page: 13 / 32

g007333
Figure 14
1. Sway link
Adjust the lower links inboard until they contact the aerator
mounting plates. This will reduce the stress on the pins.
If the tractor has sway chains instead of sway links, it is
recommended that washers be installed between the lower
link arm and lynch pin to reduce the over hung load on the
lift pins.
Note:
Refer to the tractor operator's manual for additional
installation and adjustment procedures.
6
Leveling the Aerator
Side-to-Side
No Parts Required
Procedure
1. Park the tractor and the aerator on a level, firm surface.
2. Place a level on top of the aerator frame to check for
level side-to-side (
Figure 15 ).
g007329
Figure 15
1. Level
3. Turn the adjustable link body (if provided) to raise
or lower the link arm until the aerator is leveled
side-to-side.
Note:
Refer to the tractor operator's manual for
additional adjustment procedures.
7
Adjusting the Roller Scraper
No Parts Required
Procedure
Adjust the roller scraper so that there is a gap of approximately
a 1 to 2 mm (0.06 to 0.09 inch) between the scraper and the
roller.
1. Loosen the fasteners securing each end of scraper to
roller scraper tab (
Figure 16 ).
g007330
Figure 16
1. Roller scraper 2. Nut
2. Slide the roller scraper in or out until the required
position is attained, and tighten fasteners.
3. On the ProCore 864 only, the stop bolt on the center
support may also be adjusted to attain the proper gap.
13