Toro Multi Pro 5800, Operator'S Manual

Page: 7 / 36

Setting the Low Limit Volume Value
1. Press button 1 or 2 to navigate to the
LOW LIMIT
volume option ( Figure 14 ).
g191829
Figure 14
2. Press button 4 to select the
LOW LIMIT
volume
entry ( Figure 14 ).
3. Press button 3 or 4 to raise or lower the threshold
volume at which the limit indicator displays in
the InfoCenter (
Figure 14 ).
4. Press button 5 to save the setting, exit the
TANK
screen, and return to the
SETTINGS
screen.
Setting the Preset Agitation Value (Application
Rate Mode Only)
Note:
The preset agitation setting is used to set the
sprayer pump speed when the sprayer is operated
in the Application Rate Mode with all sprayer section
shut off. The preset agitation setting controls the
percentage of sprayer pump speed. The default
preset agitation setting is 40%.
1. Identify the target sprayer pressure that you are
planning to spray—for example: 2.76 bar (40
psi). Record the pressure displayed on the dash
mounted sprayer-pressure gauge below.
Sprayer
pressure:
2. Calculate the initial agitation preset pressure
using the formula below:
Sprayer operation pressure x 1.5 to 2.0 = initial agitation preset
pressure
Example: target sprayer pressure 2.76 bar (40 psi)
x 1.5 = initial agitation preset pressure 4.1 (60 psi)
Example: target sprayer pressure 2.76 bar (40 psi) x 2.0 = initial
agitation preset pressure 5.5 bar (80 psi)
Record your
calculation here:
3. With the master section switch in the O
FF
position and the engine throttle set to the engine
speed you intend to run the machine, adjust the
preset agitation value until the sprayer system
pressure is between 1.5 to 2.0 times the target
sprayer pressure that you identified in step
1 .
For example, if you are spraying at 2.76 bar (40
psi), initially set Preset Agitation to achieve a
system pressure of 4.1 to 5.5 bar (60 to 80 psi).
Note:
If the chemicals in the sprayer tank are
foaming, lower the preset agitation value as
necessary to reduce system pressure when tank
agitation is running.
4. Press button 1 or 2 to navigate to the
AGITATION
option ( Figure 15 ).
g191830
Figure 15
5. Press button 4 to select the A
GITATION
entry
( Figure 15 ).
6. While watching the dash mounted
sprayer-pressure gauge, press button 3
or 4 to raise or lower the preset value until the
sprayer pressure is at the initial agitation preset
pressure that you calculated in step
2 ( Figure
15 ).
Note:
Do not exceed 586 kPa (85 psi) sprayer
system pressure when adjusting the preset
agitation value.
Note:
You may set the preset agitation value
higher if agitation does not cause the chemical
in the tank to foam. You may need to lower the
agitation value if agitation causes the chemical
in the tank to foam.
7. Press button 5 to save the setting, exit the T
ANK
screen, and return to the S
ETTINGS
screen.
7