Toro Multi Pro 5800, Operator'S Manual

Page: 21 / 36

If the calibration value is out of bounds
(
Figure 57 ), contact your authorized Toro
service dealer; otherwise, review the error
message and repeat the calibrations steps
in
Preparing for the Catch Test (page 16) ,
Performing the Sprayer Section Catch Test
(page 18)
, and Performing the Calibration
Calculation (page 20) .
g192864
Figure 57
3. Press button 5 to exit the Speed Calibration
screen (
Figure 55 , Figure 56 , and Figure 57 ).
4. Move the throttle to the I
DLE
position, shutoff the
engine, and remove the ignition key.
Performing the 2 Sprayer-Section Calibration
If you completed a 3-sprayer-section calibration,
the Infocenter prompts you for a 2-sprayer-section
calibration (
Figure 58 ), perform 1 of the following:
g192943
Figure 58
•
If you do not need to perform the 2-sprayer-section
calibration, press button 5 to return to the Calibrate
screen (
Figure 58 ).
•
Press button 2 to proceed to the calibration steps
in
Preparing the Sprayer Section(s) for the Catch
Test (page 17) .
Note:
You will set only the sprayer section
switches ( Figure 38 ) to the O
N
position that you
identified for calibration in Evaluating the Which
Type of Flow Calibration to Perform (page 15) .
Performing the 1-Sprayer-Section Calibration
If you completed a 3-sprayer-section calibration and
2-sprayer-section calibration, the Infocenter prompts
you for a 1-sprayer-section calibration (
Figure 59 ),
perform 1 of the following:
g192942
Figure 59
•
If you do not need to perform the 1-sprayer-section
calibration, press button 5 to return to the Calibrate
screen (
Figure 59 ).
•
Press button 2 to proceed to the calibration steps
in
Preparing the Sprayer Section(s) for the Catch
Test (page 17) .
Note:
You will set only the sprayer section switch
( Figure 38 ) to the O
N
position that you identified
for calibration in Evaluating the Which Type of
Flow Calibration to Perform (page 15) .
21