Toro Multi Pro 5800, Operator'S Manual

Page: 16 / 36

g192583
Figure 41
3. Press button 4 to select Flow calibration option
(
Figure 41 ).
4. Fill the sprayer tank half full—600 L or 150 US
gal of water (
Figure 42 ).
Note:
You can cancel the flow calibration
by pressing button 5. A message displays
confirming that you canceled the flow calibration.
g192582
Figure 42
5. Engage the parking brake ( Figure 42 ).
6. Start the engine and lower the outer sections.
7. Set the pump switch to the O
N
position ( Figure
43 ).
g192636
Figure 43
1. Sprayer-pump switch 3. Throttle
2. Agitation switch
8. Move the throttle to the F
AST
position ( Figure
43 ) and allow the engine to run for 10 minutes.
Important:
You must bring the hydraulic
system to operating temperature before
proceeding with the remaining flow
calibration steps.
Preparing for the Catch Test
1. Press button 2 to advance to the next step
(
Figure 42 ).
2. Press buttons 3 or 4 to select the nozzles
installed at the active spray position as follows:
•
For machines with nozzle colors that match
the flow rates described in
Figure 44 , select
the color of nozzles installed at the active
spray position.
•
For machines with nozzle colors that do not
match the flow rates described in Figure 44 ,
select the flow rate (gpm or lpm) of nozzles
installed at the active spray position.
16