Toro Multi Pro 41240, Operator'S Manual

Page: 92 / 96

Removing the Sprayer Skid
1. Lower the booms to approximately 45° and then
pivot them forward (
Figure 137 ).
g033619
Figure 137
2. Remove the 2 bolts (1/2 x 1-1/2 inches) and
2 locknuts (1/2 inch) that secure the hold
down bracket of the tank skid assembly to the
bed bracket on the frame at each side of the
machine; refer to
13 Lowering the Tank Skid
(page 25) .
3. Raise the tank skid with the lift cylinders, install
the cylinder lock, and perform the following:
Note:
Refer to Raising the Tank Assembly
(page 70) .
•
For HD- and HDX-Series Workman models
with a manual transmission, disconnect the
PTO shaft from the transaxle PTO; refer
to the installation instructions for the Multi
Pro WM Turf Sprayer Finishing Kit, Manual
Workman Utility Vehicle.
•
For HDX Workman with an automatic
transmission, disconnect the hoses at the
high-flow hydraulic panel and cap the fittings;
refer to the installation instructions for the
Multi Pro WM Turf Sprayer Finishing Kit,
Automatic Workman Utility Vehicle.
•
Disconnect the speed sensor wiring;
refer to
Connecting the Speed Sensor
Harness (HD-Series Models with a Manual
Transmission) (page 17)
and Connecting the
Speed Sensor Harness (HDX-Auto Model)
(page 17)
.
4. Remove the cylinder lock and lower the tank
skid with the lift cylinders; refer to
Lowering the
Tank Assembly (page 71) .
5. Attach the lifting equipment to the horizontal
tubes of the forward jack stands and the vertical
post of the rear jack stands (
Figure 137 ).
6. Lift the tank assembly 7.5 to 10 cm (3 to 4
inches), and remove the lynch pins and clevis
pins securing the lift cylinders to the tank
assembly.
7. Lift the tank skid from the machine high enough
to clear the skid from the machine (
Figure 137 ).
8. Carefully move the vehicle forward and away
from the tank skid.
9. Slowly lower the skid tank to the ground.
92