2
5. Replace the governor bracket (Fig. 3), discarding the
old governor bracket and the spring connected to it.
3
1
4
4
2
Figure 3
1.
Governor bracket
2.
Accelerator cable
3.
Throttle cable to
carburetor
4.
Security bracket
6. Replace the accelerator cable (cable which runs from
the accelerator pedal to the governor bracket) (Fig. 3).
Note: To replace the accelerator cable, you will need
to drill out the rivet securing the tamper proof bracket.
When finished, secure the bracket with a new rivet
(Fig. 3).
7. Replace and adjust the accelerator and brake pedals;
refer to 3327–218, Replacement Pedal Kit Installation
Instructions for more information.
8. Adjust the throttle cable (cable running from the
governor bracket to the carburetor) as follows (Fig. 3):
A. Turn the governor bracket as far as possible
counterclockwise and hold it (Fig. 3).
B. Adjust the cable to have free play at the carburetor,
ensuring that the throttle cable spring at the
governor bracket has no tension (Fig. 3).
9. Remove the exhaust system from the engine manifold
back through the muffler.
10. Enlarge the rear hole from which you removed the
prop rod U-bracket to 15/32 in. dia. (Fig. 4).
1
2
3
4
5
Figure 4
1.
15/32 in. dia.
2.
12 in. (30.5 cm)
3.
1/2 in. (1.25 cm)
4.
15/32 in. dia.
5.
10-21/32 in. (27 cm)
11. Drill a 15/32 in. dia. hole through the frame at the
location illustrated in Figure 4.
12. Install the new exhaust manifold, exhaust coupler,
springs, and muffler, ensuring that you align the
exhaust manifold gaskets correctly (Fig. 5).
