3
5
1
2
4
3
Figure 5
1.
Exhaust manifold
2.
Exhaust coupler
3.
Springs (only one shown)
4.
Muffler
5.
Torque arm
13. Disconnect the brown connector from the old module
in the right side of the frame and insert a dead
connector into the brown connector to seal it off
(Fig. 6).
3
1
2
Figure 6
1.
Old module
2.
Brown connector with
dead connector installed
3.
Relay
14. Install the new gray module on the side of the engine
towards the front of the engine compartment as
illustrated in Figure 7.
1
2
Figure 7
1.
New module
2.
Gray lead connected to
the ignition kill magneto
15. Install the gray lead from the module with the ring
terminal to the magneto kill terminal on top of the
brown wire already there (Fig. 7).
16. Unplug the relay connector from the relay (Fig. 8).
